Laserfiche WebLink
b. Fence monuments must be set back a minimum of five feet from all property boundaries and <br />never fewer than ten feet from the edge of the paved, traveled roadway; <br />C. An individual fence monument shall be limited to a maximum footprint of six square feet; <br />d. Fence monuments may not exceed the maximum allowed height of the associated fence, <br />including any appurtenances. Any fence monument exceeding the maximum height must meet <br />accessory structure setbacks for the appropriate district; <br />e. Building permit requirements: <br />1. A building permit is required if footings are proposed; <br />2. Construction plans with footing details are required to be submitted for permit approval; <br />3. If the fence and/or fence monuments exceed six feet in height, a building permit is <br />required. <br />(11) Entrance monuments, defined for the purpose of this section as a nearly permanent physical structure <br />or object, natural or artificial, used to depict an entrance to the property, erected in all residential <br />zoning districts are considered nonencroachments when they conform with the following standards: <br />a. Each monument, with a maximum of two per approved driveway access, shall be limited to a <br />single pillar with a footprint measuring no larger than 25 square feet and no length to exceed five <br />feet; <br />b. The monument must be setback a minimum of five feet from all property boundaries and never <br />fewer than ten feet from the edge of the paved, traveled roadway; <br />C. Plans and/or elevation views of the proposed monuments are required to be submitted for <br />approval by the planning director; <br />d. All signage proposed for the monuments must comply with article X, division 4 of this chapter; <br />e. The monuments are limited to eight feet in height, including any appurtenances. Any monument <br />exceeding the maximum height must meet principal structure setback requirements; <br />f. When more than one monument is proposed, and serving two or fewer residences, a minimum <br />horizontal width of 16 feet is required between them; <br />g. When more than one monument is proposed, and serving three or more residences, a minimum <br />horizontal width of 22 feet is required between them; <br />h. Lighting is allowed, in conformance with section 6.12.7780 and at the discretion of the planning <br />director. <br />i. A building permit is required for installation and the property corners must be located for <br />inspection purposes. <br />(12) Gates, when proposed, must meet the following requirements: <br />a. The gate must open into the property not outward towards the right-of-way; <br />b. Gates serving two or fewer residences shall have a minimum horizontal width of 14 feet in the <br />full open position; <br />C. Gates serving three or more residences shall have a minimum horizontal width of 20 feet in the <br />full open position; <br />d. For all properties, gate height may not exceed the height of the monument, measured from <br />grade, unless principal structure setbacks are met (if monuments are not proposed then gate <br />(Supp. No. 2, Update 1) <br />Created: 2026-02-18 14:00:S6 [EST] <br />Page 7 of 8 <br />177 <br />