Laserfiche WebLink
APPENDIX A 224-9 <br />A-2-2.2 Install garden hose outlets on the exterior of <br />buildings to permit hose stream protection for all sides of <br />the building and the roof. It is desirable to have some <br />outlets at least 50 ft (15.3 m) from the building for fire <br />fighting use. Where practical, hose should be racked near <br />and kept permanently connected to at least one outside <br />outlet. Drain the hose during freezing weather. <br />A-2-2.4 Because power supplies for electrically <br />operated pumps might not be completely reliable, con ­ <br />sider an alternative method of pumping water, such as a <br />portable pump. All pumps should provide sufficient <br />pressure and voiume to deliver an effective stream of <br />water to the highest part of the roof. Do not attach power <br />lines that supply energy to pumps to the house or other <br />structures. Where engine-driven pumps are used as <br />standby units only, start the engine at least weekly to <br />assure reliable response in an emergency. Pumps should <br />be drained after use to prevent damage. Where piped <br />water supplies are not available keep several full back­ <br />pack pump cans or similar units in convenient locations. <br />A>2>4 On Federal, State and Provincial forest prop­ <br />erties, instructions for sounding alarms should be posted <br />prominently. It is particularly important that every occu ­ <br />pant of a home or camp in a forested area be thoroughly <br />familiar with actions to be taken in a fire emergency, the <br />name and location of the nearest fire warden, and means <br />of notification. Camp occupants should be able to give <br />accurate directions to forestry or fire department person ­ <br />nel on how to locate the camp property. Directions <br />should be posted next to the telephone so visitors can read <br />them before or at the time of a fire emergency. <br />A-2-4.1 In a community of dwellings, cottages, or camp <br />sites, a signal to alert other property owners immediately <br />on discovery of a fire is essential. A distinctive signal <br />(siren, air horn, or bell) should be centrally available for <br />this purpose. This does not replace the need to notify the <br />nearest organized fire department or forest agency im­ <br />mediately by telephone or other alarm methods. <br />A-2-4.2 A variety of fire detectors are available for <br />homes, cottages, resort buildings and other structures. <br />These can sound an alarm inside and outside a building <br />and may be connected to a telephone or other circuit for <br />notifying the nearest forest agency or fire department. <br />Fire detectors should be tested and listed by a testing <br />laboratory. (5ee NFPA 74, Household Fire Warning <br />Equipment.) <br />A-S-1 National and regional building codes will be <br />helpful to persons who want to build new structures in <br />forested areas. In addition, a number of NFPA codes and <br />standards concerning fire protection a^c available for use <br />in constructing such properties including the following; <br />NFPA SO. Flammable and Combustible Liquids Code <br />NFPA 31, Installation of Oil Bumirxg Equipment <br />NFPA 54. National Fuel Cos Code <br />NFPA 58, Liquefied Petroleum Cases, Storage and <br />Handling <br />NFPA 70. National Electrical Code <br />NFPA 101, Lift Safety Code <br />A-3-1.1 If the building rests on supports with an open <br />space beneath, screen all such open spaces or areas under <br />floors to prevent the accumulation of leaves, litter and <br />other materials subject to fire. Do not store combustibles <br />in these spaces. Maintain at least 4 in. (10.2 cm) between <br />wood and the ground to provide adequate ventilation and <br />prevent rotting of the wood which could result in a fire <br />hazardous condition. <br />If the building has a basement or cellar, provide suffi­ <br />cient headroom lof tiie safe installation of heating equip­ <br />ment. Noncombustit le or fire-resistant matenals are <br />recommended for ceilings and walls near healing equip­ <br />ment to minimize the possibility of fire spread. Screen <br />roof and gable vents to prevent sparks from entering the <br />building <br />A-3-2.1 Install firestopping in the studding of all com ­ <br />bustible wall and concealed ceiling spaces to prevent the <br />unhampered spread of fire in such areas. Firestopping <br />consists of using wooden blocks, or noncombustible <br />material supported on metal strips to block all openings <br />or passages in walls and floors tightly to prevent the <br />passage of smoke and hot gases. This may be done at <br />moderate cost in new buildings. In old buildings it may <br />be costly and impractical to provide complete firesiop- <br />ping. Blocking, however, should at least be installed at <br />the walls between the first floor joists. <br />Build a trap door or scuttle hole and provide a ladder <br />for access to attic spaces Provide a door or other means <br />of access to the space beneath the building. <br />A-3-3.2 Locking devices should not be used which <br />would impede or prohibit escape from fire, such as chain <br />type bolts, limited opening sliding type locks and burglar <br />locks which cannot be easily disengaged by quick- <br />releasing catches. <br />A-3-3.5 Every family should practice fire exit drills in <br />homes or camps. The procedures are sinmie and easy to <br />learn but become very important in a fire emergency. <br />{See NFPA folder G-lOO, “Seconds Count Escape Plan­ <br />ner. ’•) <br />A-3-3.6 Windows may serve as a means of escape, par­ <br />ticularly where ladders can be raised by fire fighters or <br />others. Even where the location is not favorable for <br />escape, the window opening may provide air for <br />breathing in a smoke-filled building where occupants are <br />waiting vor rescue. <br />A-S-4 Combustible materials used on the interior of the <br />building may be treated with a fire-retardant coating or <br />impregnation to improve the fire resistance of such <br />materials. To be adequate, such treatment must have a <br />degree of permanency and be applied properly to pro ­ <br />duce the required resistance to fire. {See NFPA 703, Eire- <br />Retardant Treatments of Building Materials.) <br />• <br />A-3-4.1 Interior wood surfaces can be given added pro* <br />tection against rapid flame spread by treatment with a <br />fire-retardant coating. Some types of dry wall construc ­ <br />tion are conducive to flash fires. Materials included in <br />this category are untreated combustible fiberboard and <br />certain types of plywood and paperboard that delaminate