Laserfiche WebLink
<br /> <br /> <br />17 _________ <br /> Initial <br /> <br />CET Fire Pumps Mfg Drop-In-Unit <br /> <br />Tank <br />The water tank shall be constructed of 1/2" thick polypropylene sheet. The material shall <br />be of a certified, high quality, non-corrosive, stress relieved thermos plastic and black in <br />colour with a textured finish. The skid type booster tank shall be of a standard configuration <br />and shall be so designed to have complete modular slide in capability. All joints and <br />seams are to be fully welded and electronically tested for maximum strength. The unit <br />shall incorporate transverse partitions manufactured for 1/2" polypropylene which shall <br />interlock with a series of longitudinal partitions constructed of 1/2" polypropylene. All <br />swash partitions shall be so designed to allow for maximum water and air flow between <br />compartments and are fully welded to each other as well as to the inside of the tank. <br /> <br />The rear side wall of the tank shall have a standard built in Clear sight gauge tube 1/2" <br />diameter. <br /> <br />Tank will be baffles in accordance with NFPA bulletin 1900 requirements, latest version. <br /> <br />Fill tower and tank cover <br />The tank shall be equipped with a combination vent/overflow and manual fill tower. The <br />fill tower shall be an 8" round by 6" high with a moulded drop-on type cover. The cover <br />shall be attached to the tower with a rope to prevent loss. The tower shall be located in <br />the right rear corner of the tank. There shall be a vent / overflow installed inside and to the <br />extreme rear of the tower approximately 2" down from the top. This vent / overflow shall <br />be of a standard schedule 40 polypropylene pipe with minimum ID of 3". The vent / <br />overflow shall be piped internally and exit out at the passenger side tank wall with a 1" <br />extension past the wall. <br /> <br />The tank cover shall be constructed of 1/2" thick polypropylene, black in color, UV <br />stabilized. <br /> <br />Tank Capacity <br />The tank shall have a capacity of 300 U.S. gallons of water. The tank shall be covered by <br />the ALL-OUT No-Fault Life Time Warranty. <br /> <br />Sump <br />There shall be one (1) sump as standard per tank. The sump shall be integral to the tank <br />floor and be a minimum of 1/2" deep recessed into the floor. The sump shall not be visible <br />from or protrude through the bottom of the tank. <br /> <br />Tank Outlets <br />There shall be two standard tank outlets located in the same vertical plane on the driver <br />side rear wall of the tank. One (1) 2-1/2" female NPT tank to pump suction fitting and one <br />(1) 1-1/2" female NPT tank fill fitting with flow deflector <br /> <br />3/4" Tank Drain <br />There shall be a 3/4" tank drain to the rear right side of the tank with a plug. <br /> <br />Tank Mounting Blocks <br />The cover shall incorporate two (2) booster reel mounting blocks that shall be to <br />accommodate two (2) each sliding nut fasteners. These mounting blocks shall be welded <br />to the covers running from the rear edge of the tank forward. <br />184