My WebLink
|
Help
|
About
|
Sign Out
Home
Browse
Search
Ord #222 - 3rd Ser/Amending Accessory Structures and Buildings
Orono
>
Ordinances
>
Ord #222 - 3rd Ser/Amending Accessory Structures and Buildings
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
6/18/2019 2:23:33 PM
Creation date
2/16/2024 10:25:30 AM
Metadata
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
22
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
Show annotations
View images
View plain text
a. Each monument, with a maximum of two per approved driveway access, shall be <br /> limited to a single pillar with a footprint measuring no larger than 25 square feet and <br /> no length to exceed five feet; <br /> b. The monument must be setback a minimum of five feet from all property boundaries <br /> and never fewer than ten feet from the edge of the paved, traveled roadway; <br /> c. Plans and/or elevation views of the proposed monuments are required to be <br /> submitted for approval by the planning director; <br /> d. All signage proposed for the monuments must comply with Article X. Division 4 <br /> ; <br /> e. The monuments are limited to eight feet in height including any appurtenances. Any <br /> monument exceeding the maximum height must meet principal structure setback <br /> requirements; <br /> f. When more than one monument is proposed, and serving two or fewer residences, <br /> a minimum horizontal width of 16 feet is required between them; <br /> g. When more than one monument is proposed, and serving three or more residences, <br /> a minimum horizontal width of 22 feet is required between them; <br /> h. Lighting is allowed, in conformance with section 78-1573 and at the discretion of the <br /> planning director. <br /> i. A building permit is required for installation and the property corners must be located <br /> for inspection purposes. <br /> (1A1) Gates, when proposed, must meet the following requirements: <br /> a. The gate must open into the property not oufinrard towards the right-of-way, and <br /> b. Gates serving two or fewer residences shall have a minimum horizontal width of 14 <br /> feet in the full open position, and <br /> c. Gates serving three or more residences shall have a minimum horizontal width of <br /> 20 feet in the full open position, and <br /> d. For all properties, gate height may not exceed the height of the monument, <br /> measured from grade, unless principal structure setbacks are met (if monuments <br /> are not proposed then gate height shall be regulated in accordance with the fence <br /> height regulations of section 78-1405(8), and <br /> e. For locked and/or secured gates a knox box, meeting the standards set forth by the <br /> police and fire department, must be provided for emergency access, and <br /> f. On major thoroughfares the monuments and gates must be located 40 feet from the <br /> paved, traveled road to allow for vehicle stacking. A major thoroughfare for the <br /> purposes of this section means any county road or state highway. <br /> (b) The following shall not be considered to be encroachments on structure height <br /> requirements: <br /> (1) Parapet walls that extend no more than three feet above the height of the building. <br /> (2) HVAC cooling towers. <br /> (3) Elevator penthouses. <br /> SECTION 23. Section 78-1406. -Additional yard provisions shall be amended by <br /> adding and deleting text to read as follows: <br /> Page 16 of 22 <br />
The URL can be used to link to this page
Your browser does not support the video tag.