08-28-2023 Council Packet - Laserfiche WebLink

Home Browse Search

TURNING RADIUS MAY BE INCREASED (if needed) 1-3 DEGREES TO PREVENT TIRE RUB. 204254.1 - FENDER FLARES There shall be two (2) Extra Wide front fender flares installed, one (1) each side. They shall be mounted on the fenders to accommodate larger tires/wheels. More 100048.1 - FRONT AND REAR SUPER SINGLE TIRES AND WHEELS There shall be four (4) super single front and rear tires, There shall be 335/80R20 22PR, severe service radial all terrain tread. The tire weight rating shall be load range "M" (22 ply, 6780 lbs), and the speed rating shall be "K" (68 mph). There shall be four (4) wheels for the front and rear tires. There shall be 20" x 11.00" disc, ten (10)-hole pattern special order for Military/Government on/off road application with a rating to match or exceed the tire rating. WHEELS SHALL BE BLACK 100052.1 - NO SPARE TIRE No spare tire shall be supplied. 100057.1 - SPARE TIRE MOUNT There shall be no spare tire mount 100059.1 - FRONT BUMPER The factory bumper shall be removed and replaced with a heavy duty Ranchhand off-road bumper and grille protection assembly. The bumper extension unit shall be powder coated black to purchaser requirements. A receiver hitch shall be installed at the front of the apparatus in the front bumper. The bumper assembly shall be winch ready. 100610.1 - REAR TUBE BUMPER A custom fabricated 96"x4"x4"x1/4" square box tubing rear bumper shall be installed. The bumper shall have a NFPA approved black non-slip surfacing applied to the top surface. 100058.1 - REAR MUD FLAPS The chassis shall be supplied with mud flaps with the manufacturer's logo. The mud flaps shall be installed behind the rear wheels. 100063.1 - FRONT BUMPER SKID PLATE 1/4" A 1/4" (0.25") aluminum skid plate will be installed from the bumper area extending below the bumper and chassis radiator area. 100111.1 - CAB STEPS The cab shall be equipped with steel step assemblies, on each side of the cab. There shall four (4) stirrup steps mounted two (2) each side on the cab steps. They shall be installed in the best location to allow easy access to the cab. 100085.1 - CUSTOM FABRICATED CONSOLE AND SWITCH PANEL A custom fabricated DA aluminum electrical console and enclosure shall be located between the driver's and passenger's seats. It shall house the siren, switches, cup holder, map box, equipment storage, and auxiliary equipment. It shall have a custom poly faceplate. It shall extend fully to the dash. 100088.1 - CREW CAB EMS CABINET The interior cab shall be equipped with an EMS storage cabinet. The cabinet shall be located be mounted between the back cab wall and the rear of the front seats. The cabinet shall be constructed of 1/2" polyurethane. The cabinet shall be constructed to house EMS equipment. 100083.1 - WINCH -- FIXED MOUNT A Warn Winch Company Model ZEON 10,000# capacity 12-volt electric winch shall be installed in the front bumper. The unit shall include the following: Skeeter Brush Trucks Page 5 07/21/2023