2009 - 00351 - new structure - Laserfiche WebLink

Home Browse Search

t' R o CITY of ORONO iStreet Address: Mailing Address: O? 0 2750 Kelley Parkway PO Box 66 \ Orono, MN 55356 Crystal Bay, MN 55323-0066 1 11` 401,,.. t H119.4, • Residential Energy effective June 1, 2009 Information Handout Attic thickness markers. The thickness of blown in or Building certificate. A building certificate shall be posted sprayed roof/ceiling insulation shall be written in inches on in a permanently visible location inside the building. The markers that are installed at least one for every 100 sq ft certificate shall be completed by the builder and shall list throughout the attic space. The markers shall be affixed information and values of components listed in the table to the trusses or joists and marked with the minimum initial below. installed thickness with numbers a minimum of 1 inch high. Each marker shall face the attic access opening. Component Certificate requirements Spray polyurethane foam thickness and installed R-value Date certificate is installed Posted date shall be listed on the certificate provided by the insulation Dwelling or dwelling unit Mailing address and city installer. location Residential contractor Name and license number Attic insulation card. A signed and dated insulation of residential contractor receipt attic card must be attached to the framing near the Insulation installed in or on Type and installed R-value access opening, in a clearly visible place and posted with ceiling/roof, walls, slab-on- the building certificate. The attic card must identify the grade and floor type of insulation installed, the manufacturer, the installer, Rim joist and foundation Installed R-value, type and the R-value per inch, the designed settled thickness, the wall insulation whether the insulation is square footage of attic coverage area and the number of exterior, integral or interior bags installed. Fenestration Average U-factor and SHGC Ducts outside conditioned Installed R-value spaces Mechanical ventilation Type, location and design system continuous and total ventilation rates Make-up air and Type, location and size iiiilAti66, combustion air systems (if installed) Heating system Type, input rating, AFUE or HSPF, manufacturer, model It II and the structure's calculated heat loss Domestic water heater Type, size, manufacturer and model Cooling system (if installed) Type output rating, SEER, manufacturer, model, t calculated cooling load and the structure's calculated heat gain Radon control system Passive or active Telephone (952) 249-4600 • Fax (952) 249-4616 • www.ci.orono.mn.us