1993-005670 - whirlpool tub - Laserfiche WebLink

Home Browse Search

0MUNA 00WROLS o C O R P O R A I I O N ORDERING MANUAL CONTROLS Standard Spa-Side Panel "SYS" button On/Off for the circulating pump and clean-up/cool down cycle. "SYS" light A red light labeled "SYS" indicates On. "JET" button On/Off for the jet pump and Hi/Low for the 2-speed pump. "ACC" button (upper right) On/Off for the blower or other accessory. "ACC" button (lower left) On/Off for the light or other accessory. Thermostat dial Adjust temperature selection between 70° F to 104° F. Heater then comes on when the water temperature is 1° F less than the thermostat setting. "HTR" light A red light labeled "HTR" indicates heater is ready. Optional CJ In-house Master Panel "SPA" button On/Off security switch for the Spa-Side Panel. When Off, the Master Panel will control the system, and the Spa-Side Panel will only control On/Off for "ACC" (lower left). "SPA" button light A red light on the "SPA" button indicates On. "SYS" button Same as the Spa-Side Panel. "SYS" light Same as the Spa-Side Panel. "ACC" button (lower left) Same as the Spa-Side Panel. A Thermostat dial , Same as the Spa-Side Panel. "HTR" light ACC SYS Same as the Spa-Side Panel. AUTOMATIC CONTROLS IN-HOUSE MASTER PANEL Filtration Standard Clean-up/Cool-down After"SYS" is turned off, the circulating pump continues to run approximately 30-40 minutes. Provides filtration while cooling down the heater. Optional I I Periodic A time clock turns on the pump at pre-set intervals. Protection Optional [-I Freeze A sensor automatically activates the circulating pump when water and weather temperatures indicate potential freeze conditions. Optional Ll Dry-firing Heater will not activate without water pressure or flow.