Laserfiche WebLink
. , . <br /> � . �� A TI-ES <br /> Code Compliance Research Report CCRR-0101 <br /> Page 2 of 6 <br /> 4.8 AZEK Decking structural performance has 7.2 The wind uplift resistance rating <br /> been demonstrated for a temperature range of recognized in this report is based on attachment <br /> -20° F to 125° F. to treated Southern Pine framing (specific <br /> gravity, G=0.55). Installation on wood framing <br /> 5.Olnstallation with a lesser specific gravity may result in a <br /> Installation shall be in accordance with the lower wind uplift rating. <br /> manufacturer's installation instructions and this 7,3 AZEK Decking shall be fastened directly to <br /> report. Where differences occur between this supporting construction. Conventional wood <br /> report and the manufacturer's installation supporting structure is not within the scope of <br /> instructions, this report shall govern. this report and is subject to the evaluation and <br /> 5.1 AZEK Deck Boards and Porch Boards approval by the building official. Design and <br /> shall be installed with fastening as indicated in construction of supporting structure must satisfy <br /> Table 1. the design load requirements of Chapter 16 of <br /> the IBC. <br /> 5.2 AZEK 1x3% Porch Boards used as stair <br /> treads shall be installed as shown in Figure 3. 7.4 Where required by the building official, <br /> engineering calculations and details shall be <br /> 5.3 AZEK 1x5% Deck Boards used as stair provided. The calculations shall verify that the <br /> treads shall be installed as shown in Figures 3, 4 anchorage complies with the building code for <br /> and 5. the type of framing and condition of the <br /> 5.5 AZEK 1x3% Deck Boards shall not be used supporting construction <br /> as a stair tread. 7.5 The compatibility of all fasteners with <br /> 6.0 Supporting Evidence supporting structure, including chemically <br /> treated wood, is not within the scope of this <br /> 6.1 Manufacturer's drawings and installation report. <br /> instructions. <br /> 7.6 AZEK Deck Boards and Porch Boards are <br /> 6.2 Reports of testing demonstrating manufactured in Foley, AL and Moosic, PA in <br /> compliance with ICC-ES Acceptance Criteria for accordance with the manufacturer's approved <br /> Deck Board Span Ratings and Guardrail quality control system with inspections by <br /> Systems (Guards and Handrails), AC174 Architectural Testing, Inc. (IAS -AA-676). <br /> effective June 1, 2009. <br /> Exception: The capped, cellular PVC deck <br /> 6.3 Testing in accordance with ICC-ES AC174 boards are manufactured in Foley, AL only. <br /> is deemed equivalent to ASTM D 7032 for <br /> compliance with the 2009 IRC. 8.0 Identification <br /> 6.4 Quality control manual in accordance with AZEK Decking produced in accordance with this <br /> ICC-ES Acceptance Criteria for Quality Control report shall be identified with labeling on the <br /> Documents AC10, revised July 2008. individual deck boards that includes the <br /> following information: <br /> 7.0 Conditions of Use <br /> 8.1 The mark of the independent inspection <br /> The AZEK Decking applications identified in this agency, Architectural Testing, Inc. (IAS AA-676) <br /> report are deemed to comply with the intent of <br /> the provisions of the referenced building codes 8•Z The ATI Code Compliance Research <br /> subject to the following conditions. Report Number(CCRR-0101) <br /> 7.1 AZEK Decking is limited to exterior use in 9.0 Code Compliance Research Report Use <br /> Type V-B (5B)construction. 9.1 Approval of building products and/or <br /> materials can only be granted by a building <br /> official having legal authority in the specific <br /> jurisdiction where approval is sought. <br /> Architectural Testing. 130 Derry Court• York, PA 17406 717-764-7700 <br /> www.archtest.com <br />