Laserfiche WebLink
TFP780 <br /> Page 4 of 6 <br /> WITH SPRINKLER PROPERLY INSTALLED, �� �� <br /> CAREFULLY SPREAD BASE PLATES APART AND FIT Illimilll INSTALLATION <br /> ONTO SPRINKLER AT APPROPRIATE MOUNTING TOOL SECOND <br /> LOCATION PER TABLE A AND FIGURES 1 or 2 <br /> MODEL G4 GUARD till <br /> "� CLIP CLIP FULLY <br /> WITH MODEL S3 SHIELDENGAGED <br /> &SERIES TY-L UPRIGHT lit <br /> ,�,'BASESPRINKLER SHOWN �(r� �� 1` <br /> PLATES ;�— ( y <br /> FIRST �= \ -_� <br /> `Ift <br /> � FIRST CLIP FULLY �- <br /> �Illy? CLIP FULLYENGAGED „ ��ENGAGED <br /> CLIP BAR INSTALLATION <br /> SLOT /� OVW, TOOL <br /> ADJACENT `4'i - <br /> wroll <br /> BAR L . CLIP <br /> MODEL G1 GUARD& <br /> SERIES TY-FRB PENDENT •- A PLIER <br /> SPRINKLER SHOWN MAY BE <br /> INSTALLATION TOOL USED <br /> SWIVEL CLIPS OVER ADJACENT (SHIPPED WITH WITH INSTALLATION TOOL APPLIED OVER <br /> BARS AND SLIDE TOWARD BASE GUARDS) ADJACENT BARS,PRESS SECOND CLIP <br /> PLATES UNTIL SNUG TOWARD BASE PLATES UNTIL FULLY ENGAGED <br /> FIGURE 3 <br /> INSTALLATION PROCEDURE <br /> Installation NOTICE <br /> TYCO Models G1,G4,G1/S1,and G4/S3 The Clips must seat against the Base <br /> to <br /> Guards must be installed in accordance fully seatedand in order to <br /> with the following instructions. complete the installation. The Model <br /> G1, G4, G1/S1, and G4/S3 Guards may <br /> 1. Install the sprinkler in accordance be located in any position relative to the <br /> with the applicable technical data sprinkler frame arms. <br /> sheet. <br /> 2. Mount the Model G1, G4, G1/S1, or <br /> G4/S3 Guard on the sprinkler. <br /> 3. With the Clips loose, spread the <br /> two halves of the Sprinkler Guard <br /> enough to pass by the sprinkler <br /> deflector from the side. <br /> 4. Spread the two halves of the <br /> Sprinkler Guard enough to pass <br /> over the sprinkler "thread relief” or <br /> "wrenching area", as applicable, <br /> portion of the sprinkler. Refer to <br /> Table A, as well as Figures 1 and 2. <br /> 5. With the Sprinkler Guard positioned <br /> on the"thread relief"or"wrenching <br /> area" portion of the sprinkler, as <br /> applicable, engage the Clips and <br /> then slide the Clips until they seat <br /> against the Base, completing the <br /> installation as shown in Figures 1 <br /> and 2. <br /> To help assist with the sliding of the <br /> Clips,use the Guard Installation Tool <br /> as shown in Figure 3. Additionally, <br /> pliers can be used to facilitate the <br /> final seating of the Clips. <br />