Re: plmb plans - Laserfiche WebLink

Home Browse Search

� . 443 l.afayette Road N. M[NN��C3'TA D�P,A�7'1VI�N"FT C7F {651)284-5005 St.Paul,Minnesota 55155 � ��8��. & II�IDtJSTRY �$0 j DIAL-DLk www.dli.mn.gov � : TTY: 659 297-4198 Division of Consti�uction Codes and Licensing REPORT ON PLANS Plans and specifications on p2umbing: Salon, 3502 Shoreline Di;Navai7•e,Hennepin County,Minnesota,Plan No. PLB 1003-0008G OWNERSHIP: L-N-R Properties,3I5 Beiyy Sheet,Navarre,MN 55391 SUBMITTER(S): Dolder Plumbing&Heating LLC,7760 Caunty Rd 26,Maple Plain,MN 55359 Plans Dated: Date Received: Maroh 31,2010 and April 12,20 t 0 Date Revie�ved: April 13,2010 SCOPE: This revie�v is limited to fhe design of this particular project only insofar as the provisions of the Minnesota Plumbing Code,as amended, apply, and does not cover the�vater supply or sewerage system to�vhich "this plumbing system is connected. The revie�v is based upon the supposition that the data on�vhich the design is based are correct,and that necessary legal authority has been obtained to construct the project. The responsibility for the design of sriuctural features and the efficiency of equipment must be taken by the�roject designe��. Approval is contingent upon satisfactory disposition of any requirements included in this repo�-t. Special care shot�Id be taken to insure that the material and installation of the plumbing system are in accordance with the provisions of the Minnesota Plumbing Code. A copy of tiie appraved plans,specificatioits,a�id this Report on Pla�is must be re#ained at the project Iocatioi� for fiiture refereiice. INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of the Minnesota Plumbing Code. As speczfied in Minnesota Rules,part 4715.2830,no plumbing work may be covered prio�•to completing the required tests and inspections. Provisions must be made for applying an air test at the time of the roughing-in inspection as outlined in Minnesota Rules,part 4715.2820,subpart 2,of the code. A manoineter test,as specified in Minnesota Rules,part 4715.282Q subpart 3,is required at the time of the finished plumbing inspection. Tt is the responsibilify of the contractor/installer to notify the Minnesota Department of Labor and Indushy when an installation for a state contract job, licensed facility, or projeet in an ai•ea where there is no local administ�•ative authority is ready for an inspection and test. To schedule inspections,contact the state phunbing standards representative for yow•region. For your regional inspecto�•'s contact information,visit our website at http:!/�v�vw.dli.mn.gov/CCLD/CCLDContactus.asp R�QUIREMENT(S): 1. Pedicure spas and their installation must comp2y�vith ASME/ANSI Standard A 112.19.7. �ur office can find no evidence that the specified Petalo HT-135 chair is conshucted to this standard. If the pedicure chair is not marked from the factoiy as complying with ASME/ANST Standa�•d A112.19.7 or if evidence cannot be px�ovided to this office that the pedicure is listed by a third-party testing agency as ASMEIANSI Standard A112.19.7,the pedicure chairs may not be installed at this facility. 2. If the pedicure chairs have submer•ged iniets,or inlets belo�v the spill Iine of the fixture o�-equipment,each connection must be provideci�vith an approved backflo�v preventer oz•backflow preventer assembiy as specified in Minnesota Rules,part 4715.2000 and part 4715.2010. No shut-off valve may be located downsh�eam of an atmospheric vacuum breaker. Accordingiy,the backflo�v preventers must be pressare-type at rninimum and must be installed on each hot and cold�vater supply Iine to each pedic�u•e chair. This information can be provided to yoa in altemative formats(Breille,large print or audio). M Equaf Opportuniry�mployer