Laserfiche WebLink
Christine Mattson <br /> From: Christine Mattson <br /> Sent: Friday, February 22, 2013 8:23 AM <br /> To: 'Bob Renaud' <br /> Cc: 'Steve Dore' <br /> Subject: FW: 2172 Shadywood Road <br /> Attachments: Dore 1-25-13.pdf <br /> Bob, <br /> Regarding the status of the proposed driveway turnaround at 2172 Shadywood Road, see the below email to <br /> Mark Gronberg. I'm in until 1:30 today if you should have any questions. <br /> Christine� <br /> From: Melanie Curtis <br /> Sent: Tuesday, February 19, 2013 4:58 PM <br /> To: 'Mark' <br /> Cc: Christine Mattson <br /> Subject: FW: 2172 Shadywood Road <br /> I spoke to Jesse about this today and according to the Code there should be at least a 12-foot back up apron for the <br /> turnaround. Is there enough hardcover available to extend the backup area a few feet for an easier maneuver? <br /> Sec.78-1681.-Driveways,in general. <br /> All driveways shall comply with the following minimum dimensional standards: <br /> (1� Driveways serving end loading garages shall maintain a width equivalent to the width of all overhead doors extending 15 feet out from the garage <br /> doors. <br /> (2� Driveways serving side loading garages shall provide a minimum turn around or back up depth of 20 feet,as measured from the garage door(s). <br /> (3� Minimum driveway taper ratio shall be 2:1. <br /> (4� Driveways shall be at least eight feet in width at the street or private road. <br /> (5� A tumaround shall be provided for a driveway with direct access to an arterial or collector roadway, or for a side load garage as determined <br /> necessary by the city planner.The minimum dimensions of the turnaround shall be eight feet in width by 12 feet in depth. <br /> (6� "Wheel strip"driveways are allowed,but the entire width of the driveway(from outside to outside of the strips)will be considered hardcover. <br /> Melanie Curtis � 952.249.4627 � mcurtis@ci.orono.mn.us <br /> From: Mark [mailto:markgCc�gronbergassoc.com] <br /> Sent: Friday, January 25, 2013 10:43 AM <br /> To: Jesse Struve <br /> Subject: 2172 Shadywood Road <br /> Jesse: I have a lot of turning radius templates for semi trucks but not for suv's so I measured my Tahoe which has a <br /> turning radius of 21.8 feet which is close to the attached information for the Ford Excursion. I traced this on the attached <br /> survey and couldn't get this move to work in two moves going straight back and then forward. I also went out to the site <br /> and got the same results as I did on paper. However, it was pretty easy to add two extra small moves going forward a few <br /> feet and then backing up and then out the driveway. So it was easy to get out of the site,just not in two moves. <br /> i <br />