Laserfiche WebLink
' <br /> 3.2 INSTALLATION ' <br /> A. Hardware: For installation see Division 8 Section "Door Hardware." <br /> B. Manufacturer's Instructions: Install wood doors to comply with manufactarer's instructions and , <br /> referenced quality standard and as indicated. <br /> C. Job-Fit Doors: Align and fit doors in frames with uniform cleaxances and bevels as indicated , <br /> below;do not trim stiles and rails in excess of limits set by manufacturer or permitted with <br /> fire-rated doors. Machine doors for hardware. Seal cut surfaces after fitting and machining. <br /> 1. Fitting Clearances for Non-Fire-Rated Daors: Pmvide 1/8 inch (3.2 �xun) at jambs and ' <br /> heads, 1/16 inch(1.6 mm}per leaf at meeting stiles for pairs of doots, and 1/8 inch(3.2 <br /> m�) from bottom of door to top of decorative floor finish or covering. Where threshold <br /> is shown or scheduled, provide 1/4-inch (6.4-mm) clearance from bottom of doar to top ' <br /> of threshold. <br /> D. Factory-Fitted Doors: Align in frames for uniform clearance at each edge. <br /> E. Factory-Finished Doors: Restore finish before installation, if fitting or machining is required at ' <br /> the job site. <br /> F. Field-Finished Doors: Refer to the following for fmishing requi.rements: <br /> 1. Division 9 Section "Painting." <br /> 1 <br /> 2. Division 9 Section "Exterior Wood Stains." <br /> 3.3 ADNSTIIVG AND PROTECTION I <br /> A. Operation: Rehang or replace doors that do not swing or operate freely. ' <br /> B. Finished Doors: Refinish or replace doors damaged during installation. <br /> C. Pratect doors as recommended by door manufacturer to ensure that wood doors will be without ' <br /> damage or deterioration at the time of Substantial Completion. <br /> END OF SECTTON 08211 <br /> , <br /> 1 <br /> ' <br /> ' <br /> ' <br /> ' <br /> FLUSH WOOD DOORS Page 6 of 6 <br /> ' <br /> 1 <br />