Laserfiche WebLink
' <br /> C. Backprime lumber for painted finish exposed on the exterior. Compiy with requirements <br /> � for surface prepazation and application in Section "Painting." <br /> 3.3 INSTALLATION, GENERAL <br /> ' A. Do not use finish carpentry materials that are urisound, warped, bowed, twist�d, <br /> improperly treated ar finished, not adequately seasoned, or too small ta fabricate with <br /> ' proper jointi.ng arrangements. <br /> 1. Do not use manufactured units with defective surfaces,sizes,or patterns. <br /> 1 B. Install finish carpentry plumb, level,true,and aiigned with a.djacent mater�als. Use concealed <br /> shims where recjuired for alignmen� <br /> ' 1. Scribe and cut finish carpentry ta fit adjoining work. Refinish and seal cuts as <br /> recommended by manufacturer. <br /> I 2. Install to tolerance of 1/8 inch in 8 feet for plumb and level. Install adjoining fmish <br /> carpentry with 1/16 iuch rnaximurn offset for flush installation and 1/8 inch <br /> maximum offset for reveal installation. <br /> ' 3. Coordinate finish carpentry with materials and systems fhat may be in or adjacent to <br /> standing and running trim and rails. Provide cutouts for mechanicai and electrical <br /> items that penetrate exposed surfaces of trim and rails. <br /> ' C. Finish in accordance with specified requirements. <br /> � D. Refer to Division 9 Sections for final finishing of finish carpentry. <br /> 3.4 ADJUSTING <br /> � A, Repair damag�d or defective finish carpetttry where possible to elimunate fuactional or visuai <br /> defects, Where not possible to repair, replace finish carpentry. Adjust joinery for uniform <br /> appearance. <br /> I3.5 CLEANING <br /> I A, Clean finish carpenhy on exposed and semie�cgosed surfaces. Touch up factory-applied finishes <br /> to restore damaged or soiled areas. <br /> � END OF SECTION OG200 <br /> � <br /> 1 <br /> I <br /> � FINISH CARPENTRY Pa�e 5 of 5 <br /> 1 <br />